EN 1977:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designations
5 Ordering information
6 Requirements
7 Sampling
8 Test methods
9 Declaration of conformity and inspection
   documentation
10 Marking
Annex A (informative) - Information on electrical
        resistivity and conductivity relationships
Annex B (normative) - Rapid Elongation Test method
        (AR-Test) for diameter 8 mm Cu-ETP1 wire
        rod
Bibliography

This European Standard specifies the composition, mechanical, electrical and physical properties for high conductivity copper drawing stock (wire rod) suitable for fabrication into wire by cold drawing, principally for the manufacture of electrical conductors. This European Standard covers drawing stock (wire rod), in nine grades of copper and nine silver-bearing copper grades. Normally, the cross-section is approximately circular, in a range of diameters from 6 mm.