EN 60068-2-64:2008

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for test apparatus
   4.1 General
   4.2 Basic motion
   4.3 Cross-axis motion
   4.4 Mounting
   4.5 Measuring systems
   4.6 Vibration tolerances
   4.7 Control strategy
   4.8 Vibration response investigation
5 Severities
   5.1 Test frequency range
   5.2 RMS value of acceleration
   5.3 Shape of acceleration spectral density curve
   5.4 Test duration
6 Preconditioning
7 Initial measurements and functional performance test
8 Testing
   8.1 General
   8.2 Initial vibration response investigation
   8.3 Low-level excitation for equalization prior to
       testing
   8.4 Random testing
   8.5 Final vibration response investigation
9 Recovery
10 Final measurements and functional performance
11 Information to be given in the relevant specification
12 Information to be given in the test report
Annex A (informative) Standardized test spectra
Annex B (informative) Guidance
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography

IEC 60068-2-64:2008 demonstrates the adequacy of specimens to resist dynamic loads without unacceptable degradation of its functional and/or structural integrity when subjected to the specified random vibration test requirements. Broadband random vibration may be used to identify accumulated stress effects and the resulting mechanical weakness and degradation in the specified performance. This information, in conjunction with the relevant specification, may be used to assess the acceptability of specimens. This standard is applicable to specimens which may be subjected to vibration of a stochastic nature resulting from transportation or operational environments, for example in aircraft, space vehicles and land vehicles. It is primarily intended for unpackaged specimens, and for items in their transportation container when the latter may be considered as part of the specimen itself. However, if the item is packaged, then the item itself is referred to as a product and the item and its packaging together are referred to as a test specimen. This standard may be used in conjunction with IEC 60068-2-47:2005, for testing packaged products. If the specimens are subjected to vibration of a combination of random and deterministic nature resulting from transportation or real life environments, for example in aircraft, space vehicles and for items in their transportation container, testing with pure random may not be sufficient. See IEC 60068-3-8:2003 for estimating the dynamic vibration environment of the specimen and based on that, selecting the appropriate test method. The major changes with regard to the previous edition concern the removal of Method 1 and Method 2, replaced by a single method, and replacement of Annex A with suggested test spectra and removal of Annex C. Also included in this revision is the testing of soft packed specimens. Has the status of a basic safety publication in accordance with IEC Guide 104.