EN 60974-7:2013

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Environmental conditions
5 Classification
6 Test conditions
7 Protection against electric shock
8 Thermal rating
9 Pressure of the liquid cooling system
10 Resistance to hot objects
11 Mechanical provisions
12 Marking
13 Instructions for use
Annex A (informative) - Additional terminology
Annex B (normative) - Position of the welding torches
        for the heating test
Annex C (informative) - Cooled copper block
Annex D (informative) - Copper block with a hole
Annex E (informative) - Copper bars with a slot
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

IEC 60974-7:2013 specifies safety and construction requirements for torches for arc welding and allied processes. This part of IEC 60974 is applicable to manual, mechanically guided, air-cooled, liquid-cooled, motorized, spool-on and fume extraction torches. In this part of IEC 60974, a torch consists of the torch body, the cable-hose assembly and other components. This part of IEC 60974 is also applicable to a cable-hose assembly connected between a power source and ancillary equipment. This part of IEC 60974 is not applicable to electrode holders for manual metal arc welding or air-arc cutting/gouging. This third edition cancels and replaces the second edition published in 2007 and constitutes a technical revision. The significant changes with respect to the previous edition are listed below: - new requirement for degree of protection of torch coupling device (see Table 1); - scope is extended to cable-hose assembly connected between a power source and ancillary equipment (see Clause 1); - torch parts, as recommended by the manufacturer, are included in the safe plasma cutting system design (see 7.4.2); - new flammability requirement for handle material (see 11.3).