EN 61010-031:2015

FOREWORD
1 Scope and object
2 Normative references
3 Terms and definitions
4 Tests
5 Marking and documentation
6 Protection against electric shock
7 Protection against mechanical HAZARDS
8 Resistance to mechanical stresses
9 Temperature limits and protection against the spread
   of fire
10 Resistance to heat
11 Protection against HAZARDS from fluids
12 Components
13 Prevention of HAZARD from arc flash and short-circuits
Annex A (normative) - Measuring circuits for touch current
Annex B (normative) - Standard test fingers
Annex C (normative) - Measurement of CLEARANCES and
        CREEPAGE DISTANCES
Annex D (normative) - Routine spark tests on PROBE WIRE
Annex E (informative) - 4 mm CONNECTORS
Annex F (normative) - MEASUREMENT CATEGORIES
Annex G Index of defined terms
Bibliography
Annex ZA (normative) - Normative references to
         international Publications with their
         corresponding European publications

IEC 61010-031:2015 is available as IEC 61010-031:2015 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.


IEC 61010-031:2015 specifies safety requirements for hand-held and hand-manipulated probe assemblies of the types described below, and their related accessories. These probe assemblies are for direct electrical connection between a part and electrical test and measurement equipment. They may be fixed to the equipment or be detachable accessories for the equipment. It has the status of a group safety publication in accordance with IEC GUIDE 104. IEC 61010-031 is a stand-alone standard. This second edition cancels and replaces the first edition published in 2002 and Amendment 1:2008. This edition constitutes a technical revision. This edition includes the following significant changes from the first edition, as well as numerous other changes:

a) Voltages above the levels of 30 V r.m.s., 42,4 V peak, or 60 V d.c. are deemed to be HAZARDOUS LIVE instead of 33 V r.m.s., 46,7 V peak, or 70 V d.c.

b) Servicing is now included within the scope.

c) Extended environmental conditions are included within the scope.

d) New terms have been defined.

e) Tests for REASONABLY FORESEEABLE MISUSE have been added, in particular for fuses.

f) Additional instruction requirements for probe assembly operation have been specified.

g) Limit values for ACCESSIBLE parts and for measurement of voltage and touch current have been modified.

h) SPACINGS requirements for mating of CONNECTORS have been modified.

i) PROBE TIPS and SPRING-LOADED CLIPS requirements have been modified. The PROTECTIVE FINGERGUARD replace the BARRIER with new requirements.

j) Insulation requirements (6.5) and test procedures (6.6.5) have been rewritten and aligned when relevant with Part 1. Specific requirements have been added for solid insulation and thin-film insulation.

k) The terminology for MEASUREMENT CATEGORY I has been replaced with the designation "not RATED for measurements within MEASUREMENT CATEGORIES II, III, or IV".

l) The flexing/pull test (6.7.4.3) has been partially rewritten.

m) Surface temperature limits (Clause 10) have been modified to conform to the limits of IEC Guide 117.

n) Requirements for resistance of PROBE WIRES to mechanical stresses have been added in Clause 12 and a new Annex D.

o) Requirements have been added regarding the prevention of HAZARD from arc flash and short-circuits for SPRING-LOADED CLIPS.

p) A new informative Annex E defines the dimension of the 4 mm banana CONNECTORS.