EN 61280-4-1:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Fibre optic communication subsystem test procedures - Part 4-1: Installed cable plant - Multimode attenuation measurement
02-12-2009
02-02-2022
FOREWORD
1 Scope
2 Normative references
3 Terms, definitions, graphical symbols and acronyms
4 Measurement methods
5 Apparatus
6 Procedures
7 Calculations
8 Documentation
Annex A (normative) - One-cord reference method
Annex B (normative) - Three-cord reference method
Annex C (normative) - Two-cord reference method
Annex D (normative) - Optical time domain reflectometer
Annex E (normative) - Requirements for the source
characteristics for multimode measurement
Annex F (informative) - Measurement uncertainty examples
Annex G (informative) - OTDR configuration information
Annex H (informative) - Test cord insertion loss verification
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
IEC 61280-4-1:2009(E) is applicable to the measurement of attenuation of installed fibre-optic cabling using multimode fibre, typically in lengths of up to 2 000 m. This cabling can include multimode fibres, connectors, adapters and splices. Cabling design standards such as ISO/IEC 11801, ISO/IEC 24702 and ISO/IEC 24764 contain specifications for this type of cabling. ISO/IEC 14763-3, which supports these design standards, makes reference to the test methods of this standard. In this standard, the fibre types that are addressed include category A1a (50/125 um) and A1b (62,5/125 um) multimode fibres, as specified in IEC 60793-2-10. The attenuation measurements of the other multimode categories can be made, using the approaches of this standard, but the source conditions for the other categories have not been defined. The main changes with respect to the previous edition are: - An additional measurement method based on optical time domain reflectometry (OTDR) is documented, with guidance on best practice in using the OTDR and interpreting OTDR traces. - The requirement for the sources used to measure multimode fibres is changed from one based on coupled power ratio (CPR) and mandrel requirement to one based on measurements of the near field at the output of the launching test cord.
| Committee |
CLC/SR 86C
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| IEC 61280-4-1:2009 | Identical |
| NF EN 61280-4-1 : 2010 | Identical |
| NBN EN 61280 4-1 : 2010 | Identical |
| NEN EN IEC 61280-4-1 : 2009 | Identical |
| I.S. EN 61280-4-1:2009 | Identical |
| PN EN 61280-4-1 : 2010 | Identical |
| DIN EN 61280-4-1 : 2010 | Identical |
| VDE 0888-410 : 2010 | Identical |
| BS EN 61280-4-1:2009 | Identical |
| CEI EN 61280-4-1 : 2011 | Identical |
| UNE-EN 61280-4-1:2009 | Identical |