EN 62561-2:2012

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Tests
6 Electromagnetic compatibility (EMC)
7 Structure and content of the test report
Annex A (normative) - Environmental test for conductors, air
        termination rods and earth lead-in rods
Annex B (normative) - Requirements for the cross sectional
        area, mechanical and electrical characteristics, tests
        to be applied
Annex C (normative) - Requirements for dimensions, mechanical
        and electrical characteristics, tests to be applied
Annex D (informative) - Typical example calculation of conductor
        resistivity
Annex E (informative) - Typical example of calculation of the
        tensile strength of a coated material
Annex F (normative) - Flow chart of tests for air termination
        conductors, air termination rods, earth lead-in rods
        and down conductors
Annex G (normative) - Flow chart of tests for earth rods
Annex H (normative) - Flow chart of tests of joints for
        earth rods
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications
Annex ZB (informative) - Identification and differences of
         tests between EN 62561-2:2012 and EN 50164-2:2008

IEC 62561-2:2012(E) specifies the requirements and tests for: - metallic conductors (other than 'natural' conductors) that form part of the air termination system and down conductors; - metallic earth electrodes that form part of the earth termination system.