EN ISO 17405:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Non-destructive testing - Ultrasonic testing - Technique of testing claddings produced by welding, rolling and explosion (ISO 17405:2014)
16-07-2014
14-06-2022
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Ultrasonic test system
5 Preparation of the test object
6 Test procedure
7 Test report
Annex A (informative) - Determination of focal zone
Bibliography
ISO 17405:2014 specifies the techniques for manual ultrasonic testing of claddings on steel applied by welding, rolling, and explosion using single-element or dual-element probes. The test is intended to cover detection of two-dimensional or three-dimensional discontinuities in the cladding and in the region of the interface.ISO 17405:2014 does not give acceptance criteria nor define the extent of testing.
| Committee |
CEN/TC 121
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| Standards | Relationship |
| I.S. EN ISO 17405:2014 | Identical |
| NBN EN ISO 17405 : 2014 | Identical |
| ISO 17405:2014 | Identical |
| SS-EN ISO 17405:2014 | Identical |
| BS EN ISO 17405:2014 | Identical |
| PN EN ISO 17405 : 2014 | Identical |
| NF EN ISO 17405 : 2014 | Identical |
| NEN EN ISO 17405 : 2014 | Identical |
| DIN EN ISO 17405 E : 2014 | Identical |
| DIN EN ISO 17405:2014-10 | Identical |
| NS EN ISO 17405 : 2014 | Identical |
| UNE-EN ISO 17405:2015 | Identical |
| EN 12668-2:2010 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 2: Probes |
| ISO 2400:2012 | Non-destructive testing — Ultrasonic testing — Specification for calibration block No. 1 |
| EN 1330-2:1998 | Non destructive testing - Terminology - Part 2: Terms common to the non-destructive testing methods |
| EN 1330-4:2010 | Non-destructive testing - Terminology - Part 4: Terms used in ultrasonic testing |
| EN 12668-1:2010 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: Instruments |
| EN 12668-3:2013 | Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment |
| ISO 7963:2006 | Non-destructive testing — Ultrasonic testing —- Specification for calibration block No. 2 |