EN ISO 2566-2:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Steel - Conversion of elongation values - Part 2: Austenitic steels (ISO 2566-2:1984)
23-06-1999
15-01-2022
Foreword
0 Introduction
1 Scope and field of application
2 Symbols
3 Definitions
4 Basic formula
5 Conversion from one proportional gauge length to another
proportional gauge length
6 Conversion from one non-proportional gauge length
to another non-proportional gauge length for test pieces
of equal cross-sectional area
7 Conversion from a proportional gauge length to a
non-proportional gauge length
8 Conversion from a non-proportional gauge length to another
non-proportional gauge length for test pieces of different
cross-sectional areas
9 Use of figures 1 to 5
Specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths. The conversions are not applicable to cold reduced steels, quenched and tempered steels and non-austenitic steels, or where certain tensile strength ranges and dimensions are exceeded.
| Committee |
CEN/TC 459/SC 1
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| BS EN ISO 2566-2:2001 | Identical |
| PN EN ISO 2566-2 : 2011 | Identical |
| ISO 2566-2:1984 | Identical |
| I.S. EN ISO 2566-2:1999 | Identical |
| NF EN ISO 2566-2 : 1999 | Identical |
| NS EN ISO 2566-2 : 1ED 1999 | Identical |
| NBN EN ISO 2566-2 : 1ED 99 | Identical |
| PN ISO 2566-2 : 1994 | Identical |
| NEN EN ISO 2566-2 : 1999 | Identical |
| DIN EN ISO 2566-2:1999-09 | Identical |
| UNE-EN ISO 2566-2:2000 | Identical |