EN ISO 2719:2025

This document specifies three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40°C to 370°C.NOTE 1 Although, technically, kerosene with a flash point above 40°C can be tested using this document, it is standard practice to test kerosene according to ISO13736.[5] Similarly, lubricating oils are normally tested according to ISO2592.[2]Procedure A is applicable to distillate fuels (diesel, biodiesel blends, heating oil and turbine fuels), new and in-use lubricating oils, paints and varnishes, and other homogeneous liquids not included in the scope of procedures B or C.Procedure B is applicable to residual fuel oils, cutback residuals, used lubricating oils, mixtures of liquids with solids, and liquids that tend to form a surface film under test conditions or are of such kinematic viscosity that they are not uniformly heated under the stirring and heating conditions of procedure A.Procedure C is applicable to fatty acid methyl esters (FAME) as specified in specifications such as EN14214[11] or ASTMD6751.[13]This document is not applicable to water-borne paints and varnishes.NOTE 2 Water-borne paints and varnishes can be tested using ISO3679.[3] Liquids containing traces of highly volatile materials can be tested using ISO1523[1] or ISO3679.