I.S. EN 2944:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
AEROSPACE SERIES - INSERTS, SCREW THREAD, HELICAL COIL, SELF-LOCKING, IN CORROSION RESISTING STEEL FE-PA3004
Hardcopy , PDF
English
01-01-1998
13-05-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
National Foreword
European foreword
Introduction
1 Scope
2 Normative references
3 Required characteristics
4 Designation
5 Marking
6 Technical specification
Describes the characteristics of inserts, self-locking, helical coil, tanged insertion drive, screw thread in NI-PH2801, for aerospace applications.
| DocumentType |
Standard
|
| Pages |
8
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| BS EN 2944:1998 | Identical |
| NS EN 2944 : 1ED 1998 | Identical |
| NF EN 2944 : 1998 | Identical |
| NBN EN 2944 : 1998 | Identical |
| DIN EN 2944:1998-07 | Identical |
| EN 2944:1998 | Equivalent |
| NEN EN 2944 : 2018 | Identical |
| UNE-EN 2944:1998 | Equivalent |
| EN 2944:2018 | Identical |
| ISO 5855-2:1999 | Aerospace — MJ threads — Part 2: Limit dimensions for bolts and nuts |
| EN 2943:1998 | Aerospace series - Inserts, screw thread, helical coil, self-locking - Technical specification |
| EN 2947:2006 | Aerospace series - Steel FE-PA3004 (X10CrNi18-09) - Air melted - Non heat treated - Cold drawn wire - a or D ≤ 2,3 mm |
| EN 2424:2008 | Aerospace series - Marking of aerospace products |
| EN 3044:1998 | Aerospace series - Installation holes for inserts, screw thread, helical coil, self-locking - Design standard |
| EN 2945:1998 | Aerospace series - Inserts, screw thread, helical coil, self-locking - Assembly procedure |