I.S. EN 562:2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
GAS WELDING EQUIPMENT - PRESSURE GAUGES USED IN WELDING, CUTTING AND ALLIED PROCESSES
Hardcopy , PDF
English
01-01-2003
05-05-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Pressure
4.1 Unit of pressure
4.2 Maximum scale reading
4.3 Maximum pressure mark
5 Manufacturing requirements
5.1 Materials
5.2 Design and dimensions
6 Safety
7 Marking
8 Tests
8.1 General
8.2 Design and manufacturing standard
8.3 Accuracy
8.4 Torsion test
8.5 Bend test
8.6 Case vent test
8.7 Strength
8.8 Flammability test
Bibliography
Specifies requirements for Bourdon-type pressure gauges normally used with compressed gases at pressures up to 300 bar in welding, cutting and allied processes. It also covers use for dissolved acetylene and for liquefied gases under pressure.
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| BS EN 562:2003 | Identical |
| NS EN 562 : 2003 | Identical |
| EN 562 : 2003 | Identical |
| NF EN 562 : 2003 | Identical |
| NEN EN 562 : 2003 | Identical |
| NBN EN 562 : 2003 | Identical |
| DIN EN 562:2003-09 | Identical |
| UNE-EN 562:2004 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.