Preview

PIEZOELECTRIC FILTERS - PART 2: GUIDE TO THE USE OF PIEZOELECTRIC FILTERS - SECTION 2: PIEZOELECTRIC CERAMIC FILTERS

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-1999

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General terms
  3.2 Electrical properties
4 Piezoelectric ceramic resonators for filters
  4.1 General
  4.2 Mode of vibration as a function of frequency
5 Basic filter characteristics
  5.1 Types of piezoelectric ceramic filters
  5.2 Utilization and limitations
  5.3 Input level
6 Practical remarks
  6.1 Impedance matching
  6.2 Spurious response suppression
7 Measuring techniques
8 Marking
9 Specification procedure for a piezoelectric ceramic filter
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Specifies passive band-pass filters operating over the frequency range of a few kHz to more than 10 MHz which are commercially available as separate and independent units.

DevelopmentNote	For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
DocumentType	Standard
Pages	56
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
BS EN 60368-2-2:1999	Identical
EN 60368-2-2:1999	Identical
DIN EN 60368-2-2:1999-08	Identical
SN EN 60368-2-2 : 1999	Identical
IEC 60368-2-2:1996	Identical

IEC 61261-2-1:1994	Piezoelectric ceramic filters for use in electronic equipment - A specification in the IEC quality assessment system for electronic components (IECQ) - Part 2: Sectional specification - Qualification approval - Section 1: Blank detail specification - Assessment level E
IEC 60368-1:2000+AMD1:2004 CSV	Piezoelectric filters of assessed quality - Part 1: Genericspecification
IEC 61261-1:1994	Piezoelectric ceramic filters for use in electronic equipment - A specification in the IEC quality assessment system for electronic components (IECQ) - Part 1: Generic specification - Qualification approval
IEC 61261-2:1994	Piezoelectric ceramic filters for use in electronic equipment - A specification in the IEC quality assessment system for electronic components (IECQ) - Part 2: Sectional specification - Qualification approval

View more information

$105.88

Including GST where applicable

Product format

I agree to the DRM document license rules apply against the PDF selection made.

Please confirm that you agree to the document license rules for this document.

I agree to the document license rules .

Please confirm that you agree to the document license rules for this document.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

I.S. EN 60368-2-2:1999

PIEZOELECTRIC FILTERS - PART 2: GUIDE TO THE USE OF PIEZOELECTRIC FILTERS - SECTION 2: PIEZOELECTRIC CERAMIC FILTERS

Table of Contents

Abstract

General Product Information

International Equivalents

Standards Referencing This Book

Category

Subcategory