Preview

PETROLEUM AND LIQUID PETROLEUM PRODUCTS - CALCULATION OF OIL QUANTITIES - PART 2: DYNAMIC MEASUREMENT

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-1996

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

0 Introduction
1 Scope and field of application
2 References
3 Definitions
4 Hierarchy of accuracies
  4.1 Purpose and implications
  4.2 Hierarchy
5 Principal correction factors
  5.1 Purpose and implications
  5.2 C[ts]
  5.3 C[ps]
  5.4 C[pl]
  5.5 C[tl]
6 Calculation of prover volume
  6.1 Purpose and implications 6.2 Volume Standard measures
  6.3 Rule for rounding - Provers
  6.6 Corrections applied to measured-volume water draw method
  6.7 Example of calculation - Calibration of pipe prover by
                               water draw method using field
                               Standards
  6.8 Example of calculation - Calibration of tank prover by
                               water draw method using field
                               Standards
  6.9 Example of calculation - Calibration of pipe prover by
                               master meter method
7 Calculation of meter factor
  7.1 Purpose and implications
  7.2 Temperature and pressure
  7.3 Rule for rounding - Meter factors
  7.4 Calculation of Standard meter factor for a displacement
      meter, using a prover tank
  7.5 Calculation of Standard meter factor for a turbine meter,
      using a pipe prover
  7.6 Calculation of meter factor at Standard conditions for a
      displacement meter, using a master meter
8 Calculation of K-factor
  8.1 Purpose and implications
  8.2 Temperature and pressure
  8.3 Rule for rounding - K-factors
  8.4 Calculation of K-factor for a turbine meter, using a pipe
      prover
9 Calculation of measurement tickets
  9.1 Purpose and implications
  9.2 Rule for rounding - Measurement tickets
  9.3 Correction factors and accuracy
Annex A Correction factors for the effect of temperature and pressure
        on steel

Specifies the various terms (be they words or Symbols) employed in the calculation of metered Petroleum quantities.

DocumentType	Standard
Pages	34
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
UNI EN ISO 4267-2 : 1999	Identical
DIN EN ISO 4267-2:1996-12	Identical
ISO 4267-2:1988	Identical
EN ISO 4267-2:1995	Identical
BS EN ISO 4267-2:1996	Identical