IEEE DRAFT 1562 : D8 2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
ARRAY AND BATTERY SIZING IN STAND-ALONE PHOTOVOLTAIC SYSTEMS
12-01-2013
12-05-2008
Introduction
1 Overview
2 Normative references
3 Definitions
4 Outline of sizing methodology
5 Load calculation
6 Days of autonomy
7 Battery sizing and selection
8 Solar irradiance
9 PV Array sizing
10 Design verification
Worksheet 1 - System sizing
Annex A (informative) Photovoltaic module technologies
Annex B (informative) Tilt angle selection
Annex C (informative) Charge controller technologies
Annex D (informative) Examples
Annex E (informative) Bibliography
Presents information to assist in sizing the array and battery of a stand-alone photovoltaic system. Systems considered in this guide consist of PV as the only power source and a battery for energy storage. These systems also commonly employ controls to protect the battery from being over- or under-charged, and may employ a power conversion subsystem (inverter or converter).
| DocumentType |
Draft
|
| PublisherName |
Institute of Electrical & Electronics Engineers
|
| Status |
Superseded
|
| IEEE 1013-2007 | IEEE Recommended Practice for Sizing Lead-Acid Batteries for Stand-Alone Photovoltaic (PV) Systems |
| IEEE 1361-2014 | IEEE Guide for Selecting, Charging, Testing, and Evaluating Lead-Acid Batteries Used in Stand-Alone Photovoltaic (PV) Systems |
| IEEE 1013-2007 | IEEE Recommended Practice for Sizing Lead-Acid Batteries for Stand-Alone Photovoltaic (PV) Systems |
| ASTM E 1036M : 1996 : EDT 2 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells (Withdrawn 2005) |
| IEEE 484-2002 | IEEE Recommended Practice for Installation Design and Installation of Vented Lead-Acid Batteries for Stationary Applications |
| NFPA 70 : 2017 | NATIONAL ELECTRICAL CODE |
| IEEE 450-2010 REDLINE | IEEE Recommended Practice for Maintenance, Testing, and Replacement of Vented Lead-Acid Batteries for Stationary Applications |
| IEEE 937-2007 REDLINE | IEEE Recommended Practice for Installation and Maintenance of Lead-Acid Batteries for Photovoltaic (PV) Systems |