JIS B 1022:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Tolerances for fasteners -- Part 3: Plain washers for bolts, screws and nuts -- Product grades A and C
English
30-04-1999
23-12-2016
This Japanese Industrial Standard specifies a selection of tolerances for use in the preparation of the product standards for plain washers, grades A and C, for bolts, screws and nuts with nominal thread diameters from 1 mm up to and including 150 mm. Deviations from the tolerances specified in this Standard are permitted in product standards only for valid technical reasons. It is recommended that these tolerances also be used for non-standard plain washers. In cases where the maximum material principle according to JIS B 0023 is appropriate to certain features of certain products in the product standards, other tolerances may be applicable.
| DocumentType |
Standard
|
| Pages |
10
|
| ProductNote |
Japanese PDF version unavailable from Intertek Inform.
|
| PublisherName |
Japanese Standards Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 4759-3:1991 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.