NEN EN ISO 1797-1 : 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
DENTISTRY - SHANKS FOR ROTARY INSTRUMENTS - PART 1: SHANKS MADE OF METALS
12-01-2013
01-06-2017
Committees responsible
National foreword
Foreword
Introduction
Specification
1 Scope
2 Normative references
3 Classification
4 Symbols and terms
5 Requirements
6 Sampling
7 Test methods
8 Quality control
Annex A (informative) Bibliography
Table 1 - Fitting length of shank
Table 2 - Major defects
Table 3 - Acceptable quality level
Figure 1 - Type 1 shank
Figure 2 - Type 2 and Type 4 shank
Figure 3 - Type 3 shank
Figure 4 - Type 1 shank
Figure 5 - Type 2 shank
Figure 6 - Type 3 shank
Figure 7 - Type 4 shank
Defines shanks for rotary instruments used in dentistry and gives measurement methods for the verification of dimensions.
| DevelopmentNote |
Supersedes NEN ISO 1797. (09/2002)
|
| DocumentType |
Standard
|
| PublisherName |
Netherlands Standards
|
| Status |
Superseded
|
| Supersedes |
| Standards | Relationship |
| DIN EN ISO 1797-1:2011-11 | Identical |
| I.S. EN ISO 1797-1:2011 | Identical |
| ISO 1797-1:2011 | Identical |
| EN ISO 1797-1:2011 | Identical |
| BS EN ISO 1797-1:2011 | Identical |
| UNE-EN ISO 1797-1:2012 | Identical |