NF EN 62329-1 : 2006
Current
The latest, up-to-date edition.
HEAT SHRINKABLE MOULDED SHAPES - PART 1: DEFINITIONS AND GENERAL REQUIREMENTS
12-01-2013
Foreword
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Specimens
5 Classification
6 Ordering
7 Dimensions
8 Colour
9 Finish
10 Packaging
11 Labelling
12 Qualification approval requirements
13 Consignment tests
Annex A (informative) Heat shrinkable moulded shapes
(typical configuration after
recovery)
Bibliography
Applies to heat shrinkable moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection and strain relief for connector/cable terminations and multi-way transitions.
| DevelopmentNote |
Indice de classement: C93-649-1 PR NF EN 62329-1 April 2004 (04/2004)
|
| DocumentType |
Standard
|
| PublisherName |
Association Francaise de Normalisation
|
| Status |
Current
|
| Standards | Relationship |
| BS EN 62329-1:2006 | Identical |
| EN 62329-1:2006/corrigendum:2006 | Identical |
| IEC 62329-1:2005 | Identical |
| NBN EN 62329-1 : 2006 | Identical |
| DIN EN 62329-1 : 2006 COR 1 2007 | Identical |
| NF EN 62329-2 : 2006 | HEAT SHRINKABLE MOULDED SHAPES - PART 2: METHODS OF TEST |
| NFC 01 212 : 1990 | ELECTROTECHNICAL VOCABULARY - CHAPTER 212: INSULATING SOLIDS, LIQUIDS AND GASES |
| IEC 60050-212:2010 | International Electrotechnical Vocabulary (IEV) - Part 212: Electrical insulating solids, liquids and gases |
| NF EN 62329-2 : 2006 | HEAT SHRINKABLE MOULDED SHAPES - PART 2: METHODS OF TEST |
| IEC 62329-2:2006 | Heat-shrinkable moulded shapes - Part 2: Methods of test |