PD ISO/TR 15144-1:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Calculation of micropitting load capacity of cylindrical spur and helical gears Introduction and basic principles
Hardcopy , PDF
English
30-09-2014
02-10-2018
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols,
and units
4 Definition of micropitting
5 Basic formulae
6 Material parameter, G[M]
7 Velocity parameter, U[Y]
8 Load parameter, W[Y]
9 Sliding parameter, S[GF,Y]
10 Definition of contact point Y
on the path of contact
11 Load sharing factor, X[Y]
12 Contact temperature,theta[B,Y]
13 Flash temperature, theta[fl,y]
14 Bulk temperature, theta[M]
Annex A (informative) - Calculation of the permissible
specific lubricant film thickness lambda[GFP]
for oils with a micropitting test result
according to FVA-Information Sheet 54/7
Bibliography
Provides a procedure for the calculation of the micropitting load capacity of cylindrical gears with external teeth.
| Committee |
MCE/5
|
| DocumentType |
Standard
|
| Pages |
46
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO/TR 15144-1:2014 | Identical |
| ISO 6336-2:2006 | Calculation of load capacity of spur and helical gears — Part 2: Calculation of surface durability (pitting) |
| ISO 1328-1:2013 | Cylindrical gears — ISO system of flank tolerance classification — Part 1: Definitions and allowable values of deviations relevant to flanks of gear teeth |
| ISO/TR 13989-1:2000 | Calculation of scuffing load capacity of cylindrical, bevel and hypoid gears — Part 1: Flash temperature method |
| ISO/TR 13989-2:2000 | Calculation of scuffing load capacity of cylindrical, bevel and hypoid gears — Part 2: Integral temperature method |
| AGMA 925 : A | EFFECT OF LUBRICATION ON GEAR SURFACE DISTRESS |
| ISO 21771:2007 | Gears — Cylindrical involute gears and gear pairs — Concepts and geometry |
| ISO 6336-1:2006 | Calculation of load capacity of spur and helical gears — Part 1: Basic principles, introduction and general influence factors |
| ISO 53:1998 | Cylindrical gears for general and heavy engineering — Standard basic rack tooth profile |
| ISO 10825:1995 | Gears — Wear and damage to gear teeth — Terminology |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.