PREN 15507 : DRAFT 2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PACKAGING - TRANSPORT PACKAGING FOR DANGEROUS GOODS - COMPARATIVE MATERIAL TESTING OF POLYETHYLENE GRADES
31-05-2016
01-11-2017
European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test requirements
5 Test specimens
6 Facilities for testing
7 Test procedure
8 Selective testing
Bibliography
Describes material parameters, test requirements and procedures for the comparative testing of grades of high molecular weight high density polyethylene (PE-HD-HMW) and medium molecular weight high density polyethylene (PE-HD-MMW), used for the manufacture of packagings and IBCs for the transport of dangerous goods.
| Committee |
TC 261
|
| DocumentType |
Draft
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| 16/30303428 DC : 0 | Identical |
| 06/30148624 DC : 0 | Identical |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO 1133-1:2011 | Plastics — Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics — Part 1: Standard method |
| ISO 16770:2004 | Plastics — Determination of environmental stress cracking (ESC) of polyethylene — Full-notch creep test (FNCT) |
| EN ISO 179-1:2010 | Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test (ISO 179-1:2010) |
| EN ISO 1133-1:2011 | Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method (ISO 1133-1:2011) |
| EN ISO 16495:2013 | Packaging - Transport packaging for dangerous goods - Test methods (ISO 16495:2013) |
| ISO 1183-1:2012 | Plastics — Methods for determining the density of non-cellular plastics — Part 1: Immersion method, liquid pyknometer method and titration method |
| ISO 1872-2:2007 | Plastics — Polyethylene (PE) moulding and extrusion materials — Part 2: Preparation of test specimens and determination of properties |
| ISO 179-1:2010 | Plastics — Determination of Charpy impact properties — Part 1: Non-instrumented impact test |
| IMO IF200 : 2006 | INTERNATIONAL MARITIME DANGEROUS GOODS (IMDG) CODE |
| ISO 13274:2013 | Packaging — Transport packaging for dangerous goods — Plastics compatibility testing for packaging and IBCs |
| EN ISO 1872-2:2007 | Plastics - Polyethylene (PE) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 1872-2:2007) |
| ISO 16495:2013 | Packaging — Transport packaging for dangerous goods — Test methods |
| EN ISO 1183-1:2012 | Plastics - Methods for determining the density of non-cellular plastics - Part 1: Immersion method, liquid pyknometer method and titration method (ISO 1183-1:2012) |