PREN 816 : DRAFT 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SANITARY TAPWARE - AUTOMATIC SHUT-OFF VALVES PN 10
19-10-2015
01-08-2017
European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
5 Marking - Identification
6 Materials
7 Backflow protection
8 Dimensional characteristics
9 Leaktightness characteristics
10 Pressure resistance characteristics
11 Hydraulic characteristics
12 Mechanical properties - Operating force
13 Mechanical endurance or wear resistance
characteristics
14 Acoustic characteristics
Annex A (normative) - Pressure take off tees
Annex B (informative) - Acoustic classification (example)
Pertains to single and mixer taps with automatic shut-off for use with sanitary appliances installed in washrooms.
| Committee |
TC 164
|
| DocumentType |
Draft
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| 15/30328393 DC : 0 | Identical |
| ISO 3822-1:1999 | Acoustics — Laboratory tests on noise emission from appliances and equipment used in water supply installations — Part 1: Method of measurement |
| EN 246:2003 | Sanitary tapware - General specifications for flow rate regulators |
| EN 13618:2016 | Flexible hose assemblies in drinking water installations - Functional requirements and test methods |
| ISO 3822-4:1997 | Acoustics — Laboratory tests on noise emission from appliances and equipment used in water supply installations — Part 4: Mounting and operating conditions for special appliances |
| EN 1717:2000 | Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow |
| ISO 5167:1980 | Measurement of fluid flow by means of orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full |
| EN ISO 228-1:2003 | Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation (ISO 228-1:2000) |
| EN ISO 3822-4:1997 | Acoustics - Laboratory tests on noise emission from appliances and equipment used in water supply installations - Part 4: Mounting and operating conditions for special appliances |
| ISO 3822-2:1995 | Acoustics — Laboratory tests on noise emission from appliances and equipment used in water supply installations — Part 2: Mounting and operating conditions for draw-off taps and mixing valves |
| EN 13959:2004 | Anti-pollution check valves - DN 6 to DN 250 inclusive family E, type A, B, C and D |
| EN ISO 3822-2:1995 | Acoustics - Laboratory tests on noise emission from appliances and equipment used in water supply installations - Part 2: Mounting and operating conditions for draw-off taps and mixing valves (ISO 3822-2:1995) |
| ISO 228-1:2000 | Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation |
| EN 248:2002 | Sanitary tapware - General specification for electrodeposited coatings of Ni-Cr |