PREN 840-4 : DRAFT 2010
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
MOBILE WASTE CONTAINERS - PART 4: CONTAINERS WITH 4 WHEELS WITH A CAPACITY UP TO 1700 L WITH FLAT LID(S), FOR WIDE TRUNNION OR BG- AND/OR WIDE COMB LIFTING DEVICES - DIMENSIONS AND DESIGN
12-01-2013
01-12-2012
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Volumes
5 Dimensions and design
6 Nominal mass
7 Safety and health requirements
8 Testing
9 Marking
10 Designation
Annex A (informative) - Recommendations for
manufacturers of lifting devices
Annex B (informative) - A-Deviations
Describes dimensions and design requirements of mobile waste containers with 4 wheels, with flat lid(s) and capacity up to 1700 l to be used by wide trunnion or BG-lifting device and/or wide comb lifting device.
| Committee |
TC 183
|
| DocumentType |
Draft
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| PREN 840-5 : DRAFT 2010 | MOBILE WASTE CONTAINERS - PART 5: PERFORMANCE REQUIREMENTS AND TEST METHODS |
| 10/30232452 DC : 0 | BS EN 840-5 - MOBILE WASTE CONTAINERS - PART 5: PERFORMANCE REQUIREMENTS AND TEST METHODS |
| PREN 840-5 : DRAFT 2010 | MOBILE WASTE CONTAINERS - PART 5: PERFORMANCE REQUIREMENTS AND TEST METHODS |
| ISO 11469:2016 | Plastics — Generic identification and marking of plastics products |
| EN ISO 11469:2016 | Plastics - Generic identification and marking of plastics products (ISO 11469:2016) |
| PREN 840-1 : DRAFT 2010 | MOBILE WASTE CONTAINERS - CONTAINERS WITH 2 WHEELS WITH A CAPACITY UP TO 400 L FOR COMB LIFTING DEVICES, DIMENSIONS AND DESIGN |
| EN 1501-1:2011+A1:2015 | Refuse collection vehicles - General requirements and safety requirements - Part 1: Rear loaded refuse collection vehicles |
| PREN 840-6 : DRAFT 2010 | MOBILE WASTE CONTAINERS - PART 6: SAFETY AND HEALTH REQUIREMENTS |