SAE AMS2201L
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TOLERANCES Aluminum and Aluminum Alloy Bar, Rod, Wire, and Forging Stock Rolled or Cold-Finished
Hardcopy , PDF
English
01-10-1988
01-09-1994
| DocumentType |
Standard
|
| Pages |
9
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This specification covers established inch/pound manufacturing tolerances applicable to aluminum alloy rolled or cold-finished bar, rod, wire, and forging stock ordered to inch/pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term \"excl\" applies only to the higher figure of the specified range. The general temper designation \"-TX51\" is used for brevity and denotes the full temper designations -T351, -T451, -T651, -T851, and -T7351, the \"X\" representing one or more digits preceding the \"51\".
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.