STANAG 4382 : 2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SLOW HEATING, MUNITIONS TEST PROCEDURES
English
01-01-2003
06-02-2021
Gives a standard test procedure for assessing the reaction, if any, of munitions and weapon systems to a gradually increasing thermal environment at a change rate of 3.3 degree C per hour and also provides an alternative, tailorable, test procedure for assessing the reaction, if any, of munitions and weapon systems to a gradually increasing thermal environment as determined by means of a Threat Hazard Assessment (THA).
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
NATO
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| STANAG 4423 : 2003 | CANNON AMMUNITION (12.7 TO 40 MM), SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| STANAG 1402 : 2000 | GUIDELINES FOR THE NATIONAL TEST AUTHORITY (NTA) ASSESSMENT OF NAVAL AMMUNITION INTERCHANGEABILITY |
| MIL-PRF-71182 Base Document:2006 | Cartridge, 25MM: Armor Piercing Fin Stabilized Discarding Sabot with Trace (APFSDS-T), M919 |
| DEFSTAN 00-101(PT4)/1(2005) : 2005 | DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 4: GENERAL NAVAL ENVIRONMENT CATEGORY 1 |
| MIL-PRF-71140 Revision A:2006 | Cartridges, 25 Millimeter: Target Practice with Trace (TP-T) - M793 |
| DEFSTAN 00-101(PT4)/2(2008) : 2008 | DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 4: GENERIC NAVAL ENVIRONMENT |
| DEFSTAN 00-035(PT2)/5(2017) : 2017 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 2: ENVIRONMENTAL TRIALS PROGRAMME DERIVATION AND ASSESSMENT METHODOLOGIES |
| DEFSTAN 00-101(PT1)/1(2005) : 2005 | DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 1: SURFACE SHIPS |
| DEFSTAN 00-101(PT1)/2(2008) : 2008 | DESIGN STANDARDS FOR EXPLOSIVES SAFETY IN MOD SHIPS AND SUBMARINES - PART 1: SURFACE SHIPS |
| STANAG 4325 : 2002 | AIR-LAUNCHED MUNITIONS SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| AAS3P-1 : 2011 | ALLIED AMMUNITION SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING PUBLICATION - GUIDANCE |
| AOP 32 : 0 | DEMOLITION MATERIEL - ASSESSMENT AND TESTING OF SAFETY AND SUITABILITY FOR SERVICE |
| AAS3P-20 : 2017 | SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING OF LARGE CALIBER AMMUNITION GREATER THAN 40MM |
| AAS3P-12 : 2017 | SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR AIRCRAFT LAUNCHED MUNITIONS |
| STANAG 4608 : 2006 | AMMUNITION BELOW 12.7 MM CALIBRE - DESIGN SAFETY REQUIREMENTS AND SAFETY SUITABILITY FOR SERVICE (S[3]) EVALUATION |
| STANAG 4224 : 2007 | LARGE CALIBRE ARTILLERY AND NAVAL GUN AMMUNITION GREATER THAN 40 MM, SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| STANAG 4337 : 0 | SURFACE LAUNCHED MUNITION APPRAISAL, SAFETY AND ENVIRONMENTAL TESTS |
| STANAG 4519 : 0 | GAS GENERATORS, DESIGN SAFETY PRINCIPLES AND SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| STANAG 4493 : 2007 | TANK AMMUNITION, SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| STANAG 4587 : 2007 | CLOSE-IN LANDMINE DETECTOR TEST PROCEDURES |
| AOP 31 : 0 | DEMOLITION MATERIEL - DESIGN PRINCIPLES |
| STANAG 4439 : 2010 | POLICY FOR INTRODUCTION AND ASSESSMENT OF INSENSITIVE MUNITIONS (IM) |
| STANAG 4599 : 2007 | WEAPON LAUNCHED GRENADE SYSTEMS, DESIGN SAFETY REQUIREMENTS AND SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| AOP 20 : 2017 | SAFETY, ARMING AND FUNCTIONING SYSTEMS MANUAL OF TESTS |
| MIL-STD-2105 Revision D:2011 | Hazard Assessment Tests for Non-Nuclear Munitions |
| AAS3P-11 : 2017 | SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR SURFACE AND UNDERWATER LAUNCHED MUNITIONS |
| STANAG 4667 : 2011 | GUN LAUNCHED GUIDED MUNITIONS, SAFETY AND SUITABILITY FOR SERVICE EVALUATION |
| AAS3P-10 : 2011 | SAFETY AND SUITABILITY FOR SERVICE ASSESSMENT TESTING FOR SHOULDER LAUNCHED MUNITIONS |
| AOP 38 : 2006 | SPECIALIST GLOSSARY OF TERMS AND DEFINITIONS ON AMMUNITION SAFETY |
| AOP 39 : 2010 | GUIDANCE ON THE ASSESSMENT AND DEVELOPMENT OF INSENSITIVE MUNITIONS (IM) |
| STANAG 4123 : 0 | METHODS TO DETERMINE AND CLASSIFY HAZARDS OF AMMUNITION |
| STANAG 4439 : 2010 | POLICY FOR INTRODUCTION AND ASSESSMENT OF INSENSITIVE MUNITIONS (IM) |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.