14/30300605 DC : 0

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 General requirements
6 Information to be supplied by the purchaser
7 Application procedures and qualification
8 Classification of field joint coatings
9 General requirements for surface preparation,
   coating application, testing and repair
10 Hot-applied bituminous tape coatings
11 Petrolatum and wax-based tape coatings
12 Cold-applied polymeric tape coatings
13 Non-crystalline low-viscosity polyolefin
   based coatings
14 Coatings based on heat-shrinkable materials
15 Hot-applied microcrystalline wax coatings
16 Elastomeric coatings
17 Fusion-bonded epoxy (FBE) powder coatings
18 Liquid-applied coatings
19 Hot-applied polyolefin-based coatings
20 Thermal spray aluminium (TSA) coatings
Annex A (normative) - Test programmes for procedure
        for qualification trails, pre-production
        trails or production testing
Annex B (normative) - Inspection of thickness
Annex C (normative) - Holiday detection test
Annex D (normative) - Impact test
Annex E (normative) - Indentation test
Annex F (normative) - Specific electrical insulation
        resistance
Annex G (normative) - Cathodic disbondment test
Annex H (normative) - Peel-strength test
Annex I (normative) - Hot water immersion test
Annex J (normative) - Lap shear strength
Annex K (normative) - Drip resistance
Annex L (normative) - Peel strength between layers
Annex M (normative) - Thermal ageing resistance
Annex N (normative) - Thermal stability test (Hot
        air ageing)
Annex O (normative) - Bursting strength of reinforced
        backing
Annex P (normative) - Thermal analysis of epoxy power
        and cured coating film (FBE)
Annex Q (normative) - Adhesion test - Resistance to
        removal
Bibliography

BS EN ISO 21809-3.