15/30320416 DC : 0

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specifications and documentation
5 Constituent products
6 Preparation and assembly
7 Welding
8 Mechanical fastening
9 Erection
10 Surface preparation and corrosion protection
11 Geometrical tolerances
12 Inspection, testing and correction
Annex A (normative) - Additional information, list of options
        and requirements related to the execution classes
Annex B (informative) - Check-list for the content of a quality
        plan
Annex C (normative) - Geometrical tolerances
Annex D (informative) - Procedure for checking capability of thermal
        cutting processes
Annex E (informative) - Welded joints in hollow sections
Annex F (informative) - Guidance on the selection of weld classes
Annex G (normative) - Corrosion protection
Annex H (normative) - Test to determine slip factor
Annex J (normative) - Calibration test for preloaded bolts under site
        conditions
Annex K (informative) - Procedure for checking loss of preload for
        thick surface coatings
Annex L (informative) - Resin injection bolts
Annex M (informative) - Guide to flow diagram for development and
        use of a WPS
Annex N (normative) - Sequential method for fasteners inspection
Bibliography

BS EN 1090-2.