AIIM MS24 : 0
Withdrawn
Withdrawn
STANDARD TEST TARGET FOR USE IN MICROFILMING SOURCE DOCUMENT ENGINEERING GRAPHICS ON 35 MM MICROFILM
Published date
01-01-1996
Withdrawn date
09-25-2024
Sorry this product is not available in your region.
Foreword
1 Purpose and scope
2 Normative references
3 Definitions
4 Planetary camera target elements
Annexes
A Contrast and density information (Informative)
B Element 2 certification as ISO (Informative)
Figure
1 Standard test target for use in microfilming
source document engineering graphics on
35 mm microfilm
Table
1 Element and location dimensions for image
position on standard aperture cards
Defines the minimum test target elements, their composition and other criteria used by a 35mm planetary microfilm camera for microrecording engineering drawings.
| DocumentType |
Standard
|
| PublisherName |
Assoc. for Information and Image Management
|
| Status |
Withdrawn
|
| AIIM MS19 : 0 | RECOMMENDED PRACTICE FOR IDENTIFICATION OF MICROFORMS |
| AIIM MS23 : 0 | STANDARD RECOMMENDED PRACTICE - PRODUCTION, INSPECTION, AND QUALITY ASSURANCE OF FIRST-GENERATION, SILVER MICROFORMS OF DOCUMENTS |
| AIIM MS26 : 0 | 35 MM PLANETARY CAMERAS (TOP-LIGHT) - PROCEDURES FOR DETERMINING ILLUMINATION UNIFORMITY OF MICROFILMING ENGINEERING DRAWINGS |
| AIIM MS37 : 0 | RECOMMENDED PRACTICE FOR MICROPHOTOGRAPHY OF CARTOGRAPHIC MATERIALS |
| AIIM TR2 : 0 | GLOSSARY OF DOCUMENT TECHNOLOGIES |
| ISO 3272-3:2001 | Microfilming of technical drawings and other drawing office documents — Part 3: Aperture card for 35 mm microfilm |
| ISO 5-4:2009 | Photography and graphic technology — Density measurements — Part 4: Geometric conditions for reflection density |
| ISO 3334:2006 | Micrographics — ISO resolution test chart No. 2 — Description and use |
| AIIM MS41 : 0 | DIMENSIONS OF UNITIZED MICROFILM CARRIERS AND APERTURES (APERTURE, CAMERA, COPY AND FORMERLY IMAGE CARDS) |
| ISO 5-3:2009 | Photography and graphic technology — Density measurements — Part 3: Spectral conditions |
| ISO 5-2:2009 | Photography and graphic technology — Density measurements — Part 2: Geometric conditions for transmittance density |
| AIIM MS23 : 0 | STANDARD RECOMMENDED PRACTICE - PRODUCTION, INSPECTION, AND QUALITY ASSURANCE OF FIRST-GENERATION, SILVER MICROFORMS OF DOCUMENTS |
Summarise
Sorry this product is not available in your region.