AS 1654.2-1995

Gives values of the limit deviations for commonly used tolerance class for holes and shafts calculated from the information given in AS 1654.1. Graphical representations of tolerance zones for holes and shafts are given in the Annex. Identical with and reproduced from ISO 286-2:1988.

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes (zones) for holes and shafts calculated from the information given in ISO 286. This part of ISO 286 covers values for the upper deviations ES (for holes) and es (for shafts), and the lower deviations EI (for holes) and ei (for shafts) (see figure 1).NOTE - In the tables of limit deviations, the values for the upper deviation ES or es are shown above the values for the lower deviation EI or ei except for tolerance class JS and js which is symmetrical about the zero line.

First published as part of AS B132.1-1995 (being endorsement of BS 1916.1:1953 without amendment).
AS B132.2 first published 1955 (being endorsement of BS 1916.2:1953 without amendment).
AS B132.3 first published 1966 (being endorsement of BS 1916.3:1963 with amendment).
AS B132.1-1955, AS B132.2-1955 and AS B132.3-1966 revised, amalgamated and redesignated in part as AS 1654-1974.
Revised and redesignated in part as AS 1654.2-1995.