AS 2004-1977

1 - AS 2004-1977 DIMENSIONS OF CARBIDE TIPS AND TIPPED TOOLS
4 - PREFACE
5 - CONTENTS
6 - SECTION 1. SCOPE AND DEFINITIONS
6 - 1.1 SCOPE.
6 - 1.2 DEFINITIONS.
6 - 1.2.1 ‘Shall’ and ‘Should’
6 - 1.2.2 Tip blank
6 - 1.2.3 Tool
6 - 1.2.4 Right-hand cutting
6 - 1.2.5 Left-hand cutting
7 - SECTION 2. TYPES
7 - 2.1 TIP BLANKS.
7 - 2.2 TOOLS.
8 - SECTION 3. GENERAL REQUIREMENTS
8 - 3.1 TIP BLANKS, DIMENSIONS AND TOLERANCES.
8 - 3.1.1 General.
8 - 3.1.2 Dimensions.
8 - 3.1.3 Tolerance on Linear Dimensions.
8 - 3.1.4 Tolerance on Angles.
8 - 3.2 TOOLS.
8 - 3.2.1 Form and Dimensions.
9 - 3.2.2 Materials.
9 - 3.2.3 Requirements.
9 - 3.2.4 Marking.
34 - APPENDIX A - APPLICATION OF CARBIDES FOR MACHINING
34 - A1 INTRODUCTION.
34 - A2 CLASSIFICATION.
34 - A2.1 General.
34 - A2.2 Main Groups of Chip Removal.
34 - A2.3 Groups of Application.

Provides dimensions, form, and designation for five styles of carbide tip blanks and seventeen styles of tipped tools. A system of marking the tool is given, as well as some tolerances and general requirements. The tool style illustrations give some details of the cutting edge geometry.

This specification provides dimensions, form, and designation for a range of carbide tip blanks and carbide tipped tools for general use. Requirements, including tolerances and marking, are specified for carbide tipped tools, andrecommendations are given on preferred tip to be used. Shank material is specified, but not tip blank material.

Reconfirmed 1987