AS 2952.4-1988

1 - AS 2952.4-1988/ ISO7129-1982 EARTH-MOVING MACHINERY - BASIC SHAPES AND DIMENSIONS - TRACTORS WITH DOZER, GRADERS, TRACTOR-SCR
4 - CONTENTS
4 - FOREWORD
5 - 1 Scope and field of application
5 - 2 Reference
5 - 3 Cutting edges-Cross- sections- Principal shapes and basic dimensions
8 - 4 Mounting bolts-Hole location
10 - 5 Mounting bolt hole- Shapes and dimensions
11 - Annex - Principal shapes and basic dimensions of cutting edges with 140 and 280 mm hole pitch
11 - A.1 Field of application
11 - A.2 Cutting edges-Cross- sections- Principalshapes and basic dimensions
13 - A.3 Mounting bolts-Hole location

Specifies principal shapes and dimensions of the cross-section; hole location for the mounting bolts; and shapes and dimensions of holes for the mounting bolts, for cutting edges used on tractors with dozer, graders and tractor scrapers taking into consideration their interchangeability.

This International Standard specifies the - principal shapes and dimensions of the cross-section, - hole location for the mounting bolts, - shapes and dimensions of holes for the mounting bolts, for cutting edges used on tractors with dozer, graders and tractor scrapers, as defined in ISO 6165, taking into consideration the interchangeability.NOTE-Some inch figures in this International Standard are not equivalent to the corresponding millimetre figures because values which are widely used have been adopted.