AS 2955.10-1988

1 - AS 2955.10-1988 / ISO8313-1986 EARTH-MOVING MACHINERY - TESTS AND MEASUREMENTS - LOADERS - MEASUREMENT OF TOOL FORCES AND TIP
4 - CONTENTS
4 - FOREWORD
5 - 1 Scope
5 - 2 Field of application
5 - 3 References
5 - 4 Definitions
5 - 4.1 Tool forces
5 - 4.2 tipping load (at maximum outreach or at a specified height)
5 - 4.3 mass:
5 - 4.4 Hydraulic pressure
5 - 4.5 Limiting conditions
6 - 5 Apparatus
6 - 5.1 Load cell or force transducer
6 - 5.2 Wire ropes and shackles, pulley, safety chains and adjustable anchor point frames.
6 - 5.3 Hydraulic oil pressure gauge,
6 - 5.4 Apparatus for measuring linear dimensions
6 - 6 Test site
6 - 7 Preparation for test
6 - 8 Methods of measuring tool forces
6 - 8.1 General
6 - 8.2 Maximum breakout force using lift cylinders
6 - 8.3 Maximum breakout force using tilt cylinders
6 - 8.4 Lifting capacity to full lift height
7 - 9 Method of measuring tippi ng load
7 - 9.1 At maximum outreach
7 - 9.2 At specified height
7 - 10 Test report
7 - 10.1 General information on machine
8 - 10.2 Reporting results

Specifies methods for determining the tool forces and tipping loads of loaders together with their limiting conditions. Applies to wheel and crawler loaders.

This International Standard specifies methods for determining the tool forces and tipping loads of loaders, together with their limiting conditions.Field of applicationThis International Standard applies to wheel and crawler loaders as defined in ISO 6165 (see also ISO 7131).