AS IEC 62475:2019
Current
High-current test techniques - Definitions and requirements for test currents and measuring systems
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
03-01-2019
The objective of this Standard is applicable to high-current testing and measurements on both high-voltage and low-voltage equipment.
| Committee |
EL-007
|
| DocumentType |
Standard
|
| ISBN |
978 1 76072 375 0
|
| Pages |
93
|
| PublisherName |
Standards Australia
|
| Status |
Current
|
| Supersedes |
This International Standard is applicable to high-current testing and measurements on both
high-voltage and low-voltage equipment. It deals with steady-state and short-time direct
current (as e.g. encountered in high-power d.c. testing), steady-state and short-time
alternating current (as e.g. encountered in high-power a.c. testing), and impulse-current. In
general, currents above 100 A are considered in this International Standard, although currents
less than this can occur in tests.
NOTE This standard also covers fault detection during, for example, lightning impulse testing.
This standard:
- defines the terms used;
- defines parameters and their tolerances;
- describes methods to estimate uncertainties of high-current measurements;
- states the requirements which a complete measuring system shall meet;
- describes the methods for approving a measuring system and checking its components;
- describes the procedure by which the user shall show that a measuring system meets the
requirements of this standard, including limits set for uncertainty of measurement.
| Standards | Relationship |
| IEC 62475:2010 | Identical |
First published as AS IEC 62475:2019.