AS/NZS 1301.403S:1997

1 - AS/NZS 1301.403s:1997 METHODS OF TEST FOR PULP AND PAPER - BURSTING STRENGTH OF PAPER
4 - Contents
5 - Foreword
6 - Introduction
7 - 1 Scope
7 - 2 Normative references
7 - 3 Definition
7 - 3.1 bursting strength:
7 - 4 Principle
7 - 5 Apparatus
7 - 5.1 Burst tester,
8 - 5.2 Clamping,
9 - 5.3 Diaphragm,
9 - 5.4 Fluid pump,
9 - 5.5 Pressure measuring system,
9 - 5.6 Hydraulic fluid,
10 - 6 Preparation of test pieces
10 - 7 Procedure
11 - 8 Calculation
11 - 9 Report
11 - 10 Precision
12 - Annex A - Care and maintenance of the bursting strength tester
12 - A.1 Regular routine inspection
12 - A.2 Periodic checks of the hydraulic system
12 - A.3 Installation of a new diaphragm
13 - A. 4 Adjusting the fluid volume for service
14 - A. 5 Pressure height test
14 - A. 6 Installation of a new pressure measuring system
14 - A. 7 Checking the clamping pattern
14 - A. 8 Checking the hydraulic system for air
15 - A. 9 Checking the hydraulic system for leaks
15 - A. 10 Verification of bursting strength testers
16 - Annex B - Measuring the pumping rate
16 - B.1 Non-cam-operated testers
16 - B.2 Cam-operated testers
17 - Annex C - Setting the clamping pressure
17 - C.1 Cam and lever clamps
17 - C.2 Power-operated clamps
18 - Annex D - Calibration of electronic sensor systems
18 - D.1 Apparatus
18 - D.2 Procedure
19 - Annex E - Bibliography

This standard prescribes the procedure to be used for the determination of bursting strengthof paper by means of a burst tester.

This standard prescribes the procedure to be used for the determination of bursting strength of paper by means of a burst tester.

Recommended Practice 1961.
Revised 1973.
Standard 1989.
This edition 1997.