BS 1470:1987

Foreword
Committees responsible
Specification
1 Scope
2 Definitions
3 General requirements
4 Chemical composition
5 Tempers
6 Mechanical properties
7 Tolerances on dimensions
8 Freedom from defects
9 Selection of test samples
10 Test methods
11 Retests
12 Certificate of conformity
Appendices
A Information to be supplied by the purchaser
B Details of the international alloy designations and
    chemical composition limits for wrought aluminium
    alloys
C Alloy and temper designation cross-references
D Temper designation system
E The rounding of numbers rule
Tables
1 Chemical composition limits and mechanical
    properties of unalloyed aluminium plate, sheet and
    strip
2 Chemical composition limits and mechanical
    properties of aluminium alloy plate, sheet and
    strip (non-heat-treatable)
3 Chemical composition limits and mechanical
    properties of aluminium alloy plate, sheet and
    strip (heat-treatable)
4 Thickness tolerances for hot and cold rolled plate,
    sheet and strip
5 Width tolerances for hot and cold rolled plate and
    sheet
6 Width tolerances for coiled strip
7 Length tolerances for hot and cold rolled plate and
    sheet
8 Squareness tolerances for plate and sheet
9 Lateral curvature tolerances for plate and sheet
10 Flatness tolerances (transverse arch and
    longitudinal arch)
11 Alloy and temper designation cross-references
Figures
1 Lateral curvature of plate or sheet of length L
2 Transverse arch
3 Longitudinal arch
4 Buckles
5 Edge waves

Chemical composition, mechanical properties, dimensional tolerances, selection of test samples and test methods for three grades of unalloyed aluminium and 10 aluminium alloys in various tempers and conditions.