BS 1916-2:2009
Current
Limits and fits for engineering Guide to the selection of fits in BS 1916-1
Hardcopy , PDF
English
09-30-2009
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Terminology
5 Hole tolerances
6 Classification of fits
7 Choice of fit
8 Choice of tolerance
9 Preferred sizes
10 Recommended tolerances for standard fits
Bibliography
Provides guidance on the selection of fits given in BS 1916-1. It applies in particular, to fits between cylindrical parts, designated as "holes" and "shafts", in which case the term "size" refers to the diameter of the mating parts.
| Committee |
TPR/1/10
|
| DevelopmentNote |
Supersedes BS 1916-2(1953) & 09/30192611 DC. (09/2009)
|
| DocumentType |
Standard
|
| Pages |
46
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This British Standard gives guidance on the selection of fits given in BS1916‑1.
The recommendations apply, in particular, to fits between cylindrical parts, designated as “holes” and “shafts”, in which case the term “size” refers to the diameter of the mating parts. The recommendations are also applicable to parts other than cylindrical, in which case the term “size” refers to a length, width or other dimension.
Tables of preferred sizes are included to avoid the indiscriminate selection of dimensions, and their use is strongly recommended.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.