• There are no items in your cart

BS 4300-4(1973) : 1973

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

WROUGHT ALUMINIUM AND ALUMINIUM ALLOYS FOR GENERAL ENGINEERING PURPOSES (SUPPLEMENTARY SERIES) - 6464 SOLID EXTRUDED BARS AND SECTIONS SUITABLE FOR BRIGHT TRIM/REFLECTOR APPLICATIONS

Available format(s)

Hardcopy , PDF

Superseded date

06-15-2001

Language(s)

English

Published date

01-01-1973

Co-operating organizations
Foreword
Specification
1 General
1.1 Scope
1.2 Definitions
2 General requirements
2.1 General
2.2 Freedom from defects
2.3 Chemical composition
2.4 Condition
2.5 Sizes and tolerances
2.6 Selection of test samples
2.7 Mechanical tests
2.8 Retests
2.9 Certificate of compliance
2.10 Inspection
2.11 Independent test
2.12 Facilities for testing
2.13 The rounding of numbers rule
3 Specific requirements
3.1 Chemical composition
3.2 Mechanical properties
3.3 Tolerances
3.4 Normal radii for corners
Appendices
A Standard sizes of material
B Details of the international alloy designations
      and chemical composition limits for wrought
      aluminium alloys system
Tables
1 Heat-treatable materials; grouping into batches
2 Table deleted
3 Tensile test
4 Tolerances on diameter and length of round bar
      intended for use on automatic lathes
5 Tolerances on width and diameter of bars and
      regular sections
6 Tolerances on thickness of bars and regular
      sections
7 Tolerances on open ends of channels and I-beams
8 Angular tolerances for extruded sections
9 Tolerances on length
10 Tolerances on straightness for extruded bar and
      regular sections
11 Tolerances on twist for extruded sections
12 Normal radii for corners
Figure
1 Tolerances on open ends of channels and I-beams

Describes solid bars and sections of diameter or minor cross sectional dimension not exceeding 50mm in an aluminium alloy suitable for bright trim/reflector applications.

Committee
NFM/35
DocumentType
Standard
Pages
22
PublisherName
British Standards Institution
Status
Superseded
SupersededBy

BS 1474:1987 Specification for wrought aluminium and aluminium alloys for general engineering purposes: bars, extruded round tubes and sections
BS 1615:1987 Method for specifying anodic oxidation coatings on aluminium and its alloys
BS 2646-1:1993 Autoclaves for sterilization in laboratories Specification for design, construction, safety and performance

View more information
US$156.93
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.