BS 7215:1990

Committees responsible
Foreword
Specification
1 Scope
2 Definitions
3 Voltage designation
4 Environmental conditions
5 Classification and ratings
6 Interchangeability
7 Marking and identification
8 Construction
9 Means of operation
10 Schedule of tests
11 Associated cable sizes
Appendices
A Immersion test
B Calibration of conductor heating current
C 1 min and 100 h a.c. dry withstand test
D Partial discharge measurement
E Electrical heat cycling test
F Impulse voltage withstand test
G Humidity test
Tables
1 Classification of separable connectors
2 Dimensions of bushings
3 Dimensions of intermediate bushings
4 Voltage ratings and characteristics
5 Bushing current rating
6 Sequence of type tests for screened separable
    connectors
7 Cable cross-sectional areas and minimum levels of
    short-circuit current
8 Test voltages
Figures
1 Typical components of type A non-extensible
    separable insulated connector system
2 Typical components of type D extensible separable
    insulated connector system
3 Test circuit arrangement
4 Comparison of interface profiles
5 Voltage detection
6 Typical voltage testing procedure
7 Typical earthing adaptor for separable connectors

Requirements for construction and methods of test for dead-break separable insulated cable connector systems for use on power distribution systems.