BS 7613:1994

Committees responsible
Foreword
Specification
1 Scope
2 References
3 Definitions
4 General
5 Information to be supplied by the purchaser
6 Steelmaking process
7 Supply condition
8 Chemical composition
9 Weldability
10 Quality of finished steel
11 Identification of cast
12 Marking
13 Test certificates
14 Mass of steel
15 Tolerances
16 Selection and identification of test samples
17 Number of tensile tests
18 Direction and position of tensile test samples
19 Tensile test pieces
20 Tensile test
21 Number of impact tests
22 Position of impact test samples
23 Impact test pieces
24 Impact tests
25 Bend tests
26 Retests
Annexes
A (informative) Comparison between designations in
    this standard and the BS 4360 : 1990
B (normative) Options
C (normative) Positions of test samples for tensile
    test
D (normative) Position of test piece to be taken from
    tensile test samples when two rolled surfaces
    cannot be retained
E (normative) Position of test samples for impact
    tests
F (informative) Indicative Charpy V-notch impact
    values at temperatures other than those given in
    table 3
G (normative) Bend test for thicknesses up to and
    including 25 mm
Tables
1 Permitted deviations in product analysis from
    specified ladle analysis percentages
2 Chemical composition (ladle analysis)
3 Mechanical properties
4 Maximum CEV
5 Indicative Charpy V-notch impact values
6 Bend test requirements for thicknesses up to and
    including 25 mm
7 Recommended minimum internal forming diameters for
    guidance only
Figures
1 Location of impact test pieces
2 Positions of test samples for tensile test
3 Position of test piece to be taken from tensile test
    samples when two rolled surfaces cannot be retained
4 Position of test samples for impact tests
List of references

Specifies requirements for weldable steels for general structural and engineering purposes in the form of hot rolled quenched and tempered plates. Coverage includes definitions, steelmaking process, chemical composition, weldability, marking, tolerances, and number of tensile tests. Also gives detailed tables, diagrams and annexes.