BS 8666:2000

Committees responsible
Foreword
1 Scope
2 Normative references
3 Terms and Definitions
4 Notation
5 Form of Schedule
6 Form of bar or fabric label
7 Dimensions
8 Scheduling
9 Tolerances on cutting and bending dimensions
10 Radius of bending
11 Bending of fabric reinforcement
12 Fabrication and routine inspection
Annex A (normative) Routine inspection
Annex B (informative) Third party certification and batch
                      testing
Annex C (normative)
Figure 1 - Fabric notation
Figure 2 - Form of bar schedule
Figure 3 - Form of fabric schedule
Figure 4 - Dimensioning of an acute angle
Figure 5 - Dimensioning of cranked bars
Figure 6 - Example of bar with more than one bend
Figure 7 - Position of welded transverse wires
Figure C.1 - Purpose made fabric example
Table 1 - Standard shapes, their method of measurement and
             calculation of length
Table 2 - Standard fabric types and stock sheet size
Table 3 - Minimum scheduling radius, former diameter and bend
             allowances
Table 4 - Tolerances
Table 5 - Maximum limit for which a preformed radius is
             required
Table A.1 - Frequency of inspection

Defines requirements for dimensioning, scheduling, bending, and cutting of steel reinforcement for concrete conforming to BS 4449, BS4482, BS4483 and BS6744.