BS AU 217-1a:1987
Withdrawn
Maximum road speed limiters for motor vehicles Specification for installed requirements
Hardcopy , PDF
English
05-29-1987
05-22-2026
Foreword
Committees responsible
Specification
Section one. General
1. Scope
2. Definitions
Section two. Performance
3. Speed control on level ground
4. Speed control on descending gradients
5. Failure modes
6. Checking and calibration
Section three. Installation
7. General
8. Tamper-proofing
9. Power supply
10. Marking
Appendix
A. Test conditions and procedure for demonstrating
compliance with speed control requirements
Figure
1. Allowed tolerances of limiter response characteristic
Performance and installation of devices designed to limit the maximum road speed by the control of engine power.
| Committee |
AUE/13
|
| DevelopmentNote |
Supersedes 86/75132 DC (11/2005) Reviewed and confirmed by BSI, January 2011. (12/2010)
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
British Standards Institution
|
| Status |
Withdrawn
|
Withdrawn:This standard is no longer used
| DEFSTAN 23-6/3(2000) : 2000 | GUIDE TO THE COMMON TECHNICAL REQUIREMENTS FOR MILITARY LOGISTIC VEHICLES AND TOWED EQUIPMENT |
| BS AU 217-2:1989 | Maximum road speed limiters for motor vehicles Specification for system and component requirements |
| BS AU 217-2:1989 | Maximum road speed limiters for motor vehicles Specification for system and component requirements |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.