BS EN 10028-1:2017

European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Tolerances on dimensions
5 Calculation of mass
6 Classification and designation
7 Information to be supplied by the purchaser
8 Requirements
9 Inspection
10 Sampling
11 Test methods
12 Marking
Annex A (informative) - Changes to the previous version
        EN 10028-1:2007+A1:2009
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 2014/68/EU
aimed to be covered

Defines general technical delivery conditions for flat products for the construction of pressure equipment.

This European Standard specifies general technical delivery conditions for flat products for the construction of pressure equipment. The general technical delivery conditions in EN 10021 also apply. NOTE Once this European Standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.