BS EN 10083-2:2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification and designation
   4.1 Classification
   4.2 Designation
5 Information to be supplied by the purchaser
   5.1 Mandatory information
   5.2 Options
6 Manufacturing process
   6.1 General
   6.2 Deoxidation
   6.3 Heat treatment and surface condition at delivery
   6.4 Cast separation
7 Requirements
   7.1 Chemical composition, hardenability and mechanical
       properties
   7.2 Machinability
   7.3 Shearability of semi-finished products and bars
   7.4 Structure
   7.5 Internal soundness
   7.6 Surface quality
   7.7 Dimensions, tolerances on dimensions and shape
8 Inspection
   8.1 Testing procedures and types of documents
   8.2 Frequency of testing
   8.3 Tests to be carried out for specific inspection
9 Preparation of samples and test pieces
   9.1 Selection and preparation of samples for chemical
       analysis
   9.2 Location and orientation of samples and test pieces
       for mechanical tests
   9.3 Location and preparation of samples for hardness
       and harden ability tests
   9.4 Identification of samples and test pieces
10 Test methods
   10.1 Chemical analysis
   10.2 Mechanical tests
   10.3 Hardness and hardenability tests
   10.4 Retests
11 Marking, labelling, packaging
Annex A (normative) Options
Annex B (informative) Comparison of steel grades specified
        in this European Standard and ISO 683-1:1987 and
        other steel grades previously standardized nationally
Bibliography

Describes the technical delivery requirements for: - Semi-finished products, hot formed, e.g. blooms, billets, slabs; - Bars; - Rod; - Wide flats; - Hot-rolled strip and sheet/plate; - Forgings.

This part of EN 10083, in addition to Part 1, specifies the technical delivery requirements for: semi-finished products, hot formed, e.g. blooms, billets, slabs (see NOTES 2 and 3 in EN 10083-1:2006, Clause 1), bars (see NOTE 2 in EN 10083-1:2006, Clause 1), rod, wide flats, hot-rolled strip and sheet/plate, forgings (see NOTE 2 in EN 10083-1:2006, Clause 1), manufactured from the direct hardening non alloy steels for quenching and tempering and the non alloy flame and induction hardening steels and supplied in one of the heat treatment conditions given for the different types of products in Table 1, lines 2 to 7, and in one of the surface conditions given in Table 2. The steels are generally intended for the manufacture of quenched and tempered, flame or induction hardened machine parts, but can also be used in the normalized condition. The requirements for mechanical properties given in this document are restricted to the sizes given in Table 9 and Table 10. NOTE This document does not apply for bright steel products. For bright steel products EN 10277-1 and EN 10277-5 apply. In special cases, variations in these technical delivery requirements or additions to them may be agreed at the time of enquiry and order (see Annex A).