BS EN 10226-2:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and explanations
5 Dimensions
6 Designation
7 Thread design
  7.1 Thread form
  7.2 Thread lengths
8 Gauging
Bibliography

Defines the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads.

This European Standard specifies the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads. These threads are taper external and taper internal and are intended for use with pipes suitable for threading and for valves, fittings or other pipeline equipment interconnected by threaded joints. An appropriate thread sealant or jointing compound should be used on the thread to ensure pressure-tight joints. NOTE1 Threaded joints using taper external threads and parallel internal threads are detailed in EN10226‑1 . NOTE2 The requirements for taper external threads are identical in EN10226‑1 and EN10226‑2 . NOTE3 For pipe threads where pressure-tight joints are not made on the threads see ENISO228‑1 . NOTE4 EN10226‑3 gives details of recommended gauging systems for the verification of thread dimensions and thread form.