BS EN 10228-3:2016

European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Mandatory information
5 Test procedure
6 Personnel qualification
7 Equipment and accessories
8 Routine calibration and checking
9 Stage of manufacture
10 Surface condition
11 Test sensitivity
12 Scanning
13 Classification
14 Recording levels and acceptance criteria
15 Sizing
16 Test report
Annex A (informative) - Maximum testable depth and
        corresponding beam path range for circumferential
        angle beam scans
Annex B (informative) - Amplitude of indication in dB
        relative to % DAC
Annex C (informative) - Significant technical changes to
        the version EN 10228-3:1998

Specifies the techniques to be used for the manual, pulse-echo, ultrasonic testing of forgings manufactured from ferritic and martensitic steel.

This European Standard describes techniques to be used for the manual, pulse-echo, ultrasonic testing of forgings manufactured from ferritic and martensitic steel. Mechanized scanning techniques, such as immersion testing, may be used but should be agreed between the purchaser and supplier (see Clause4). This part of EN10228 applies to four types of forgings, classified according to their shape and method of production. Types1, 2 and 3 are essentially simple shapes. Type4 covers complex shapes. This part of EN10228 does not apply to: closed die forgings; turbine rotor and generator forgings. Ultrasonic testing of austenitic and austenitic-ferritic stainless steel forgings is the subject of EN10228‑4 .