BS EN 124-6:2015

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Materials
5 Requirements
6 Testing
7 Assessment and verification of constancy of
  performance - AVCP
8 Designation
9 Marking
Annex A (normative) - Characteristics of glass fibres used for
        reinforcement of PP polymer
Annex B (normative) - Test of deflection under load
Annex ZA (informative) - Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Regulation
Bibliography

Pertains to manhole tops and gully tops made of Polypropylene (PP), Polyethylene (PE) or unplasticized poly(vinyl chloride) (PVC-U) by a moulding or extrusion process, with a clear opening up to and including 1000 mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic.

This European Standard applies to manhole tops and gully tops made of Polypropylene (PP), Polyethylene (PE) or unplasticized poly(vinyl chloride) (PVC-U) by a moulding or extrusion process, with a clear opening up to and including 1000mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic. It is applicable to manhole tops and gully tops for use in areas which can only be used by pedestrians and pedal cyclists (class A 15), and pedestrian areas and comparable areas, car parks or car parking decks (class B 125). This European Standard gives guidance for combinations of covers/grating made of PP, PE or PVC–U with frames according to EN124‑2 , EN124‑3 , EN124‑4 and EN124‑5 . This European Standard is not applicable in isolation but only in combination with EN124‑1 . This European Standard is not applicable to: rodding point covers according to EN13598‑1 ; gratings/covers as part of prefabricated drainage channels according to EN1433 ; floor and roof gullies in buildings which are specified in EN1253 (all parts); surface boxes.