BS EN 13355 : 2004

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
  4.1 General
  4.2 Mechanical hazards
  4.3 Electrical hazards
  4.4 Thermal hazards
  4.5 Hazards generated by noise
  4.6 Hazards generated by radiation
  4.7 Hazards resulting from dangerous substances
  4.8 Fire and explosion hazards
  4.9 Hazards caused by failure of the energy supply
       and malfunction of the control system
  4.10 Hazards caused by emergency stop devices
5 Safety requirements and/or measures
  5.1 General
  5.2 Mechanical
  5.3 Electrical
  5.4 Thermal
  5.5 Noise
  5.6 Radiation
  5.7 Safety requirements against dangerous substances
  5.8 Fire and explosion prevention and protection
  5.9 Failure of energy supply and malfunction of
       the control system
  5.10 Emergency stop devices
6 Verification of the safety measure and/or measures
  6.1 General
  6.2 Mechanical
  6.3 Electrical
  6.4 Thermal
  6.5 Noise
  6.6 Radiation
  6.7 Dangerous substances
  6.8 Fire and explosion
  6.9 Failure of energy supply
  6.10 Emergency stop devices
7 Information for use
  7.1 General
  7.2 Instruction handbook
  7.3 Marking
Annex A (normative) - Determination of concentration
        of flammable solvents in terms of LEL (spraying
        mode)
      A.1 Equations
      A.2 Examples of calculation
Annex B (normative) - Measurement of air velocities
      B.1 Instrumentation
      B.2 Measurement conditions
Annex C (informative) - Classification of material's
        reaction to the fire - National standards
Annex D (informative) - References to national
        exposure limit values
Annex E (informative) - Equivalence between zone
        description and categories of ignition protection
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC, amended by 98/79/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

Pertains to combined booths for the application of organic liquid coating materials by an operator with maximum drying temperature of 100 degrees C and deals with all hazards significant for combined booths, when they are used as intended and under the conditions foreseen by the manufacturer.