BS EN 1337-2:2004

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and
   abbreviations
4 Functional requirements
5 Material properties
6 Design requirements
7 Manufacturing, assembly and tolerances
8 Conformity evaluation
9 Installation
10 Criteria for in-service inspection
Annex A (informative) Reduced area sliding
        elements
Annex B (informative) Coefficient of friction
        for dimpled PTFE sheets
Annex C (informative) Method for calculating the
        deformation of backing plates attached to
        concrete
Annex D (normative) Test methods for friction
Annex E (normative) Hard chromium plated surfaces -
        Ferroxyl test
Annex F (normative) Thickness measurement of the
        anodized surfaces
Annex G (normative) Lubricant - Oil separation test
Annex H (normative) Oxidation stability of lubricant
Annex J (normative) Austenitic steel sheets adhesive
        - Lap shear test
Annex K (normative) Factory Production Control (FPC)
Annex L (informative) Audit testing
Bibliography

Specifies the characteristics for the design and manufacture of sliding elements and guides which are not structural bearings but only parts of them for combination with structural bearings as defined in other Parts of this European Standard.

This European Standard specifies the characteristics for the design and manufacture of sliding elements and guides which are not structural bearings but only parts of them for combination with structural bearings as defined in other Parts of this European Standard. Suitable combinations are shown in Table 1 of EN 1337-1:2000. Sliding surfaces with a diameter of the circumscribing circle of single or multiple PTFE sheets less than 75 mm or greater than 1500 mm, or with effective bearing temperatures less than -35°C or greater than 48°C are outside the scope of this European Standard. Sliding elements for use as temporary devices during construction, for example during launching of the superstructure, are also outside the scope of this European Standard. In this standard the specification is also given for curved sliding surfaces which are not part of separate sliding elements but which are incorporated in cylindrical or spherical PTFE bearings as per EN 1337. NOTE The general principles detailed in this European Standard may be applied for sliding elements outside this scope, but their suitability for the intended use should be proven.