BS EN 14140:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Materials
5 Design
6 Construction and workmanship
7 Tests and examinations
8 Technical requirements for type approval
9 Initial inspection and tests
10 Marking
11 Documentation
12 Certification
Annex A (normative) - Additional manufacturers markings
Annex B (informative) - Over-moulded cylinder
Annex C (informative) - Hot Air Balloon Cylinders
Annex D (informative) - Environmental checklist
Bibliography

Describes the minimum requirements for the design, construction and testing during manufacture of transportable refillable welded steel Liquefied Petroleum Gas (LPG) cylinders, of water capacity from 0,5 l up to and including 150 l, exposed to temperatures of -20 degree C to +65 degree C.

This European Standard specifies the minimum requirements for the design, construction and testing during manufacture of transportable refillable welded steel Liquefied Petroleum Gas (LPG) cylinders, of water capacity from 0,5l up to and including 150l, exposed to temperatures of -20°C to+65°C. It allows alternative design and construction methods to those required in EN1442 , including coated cylinders, over-moulded cylinders and cylinders for hot air balloons. This European Standard applies only to pressure receptacles with a circular cross-section. This European Standard does not include the equipping of the cylinders with valves and other service equipment.