BS EN 14419:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
District heating pipes. Preinsulated bonded pipe systems for directly buried hot water networks. Surveillance systems
Hardcopy , PDF
10-28-2019
English
04-30-2009
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Basic functional requirements
4.1 Dependency of Manufacturer of pipe elements
4.2 Performance
5 Manufacture of measuring elements
5.1 General requirements
5.2 Installation, assembly and operation
5.3 Characteristics
5.4 Reliability
5.5 Maintenance
5.6 Longitudinal tightness
5.7 Marking of measuring elements
5.8 Technical documentation
5.8.1 General
5.8.2 For installation of measuring wires within
pipe elements
5.8.3 For assembly of measuring elements in the
field
5.8.4 For operation of a surveillance system
6 Manufacture of pipe elements with measuring elements
6.1 General requirements
6.2 Compatibility test
6.2.1 Before series production
6.2.2 Test procedure
6.2.3 Replication of test
6.3 Installation of measuring elements
6.3.1 Restrictions regarding type of measuring
element
6.3.2 No electrical contact
6.3.3 Connections
6.3.4 Geometry of installation
6.3.5 Spacers
6.3.6 Mechanical tightening
6.4 After pipe element manufacturing
6.5 Measuring wires at free ends
6.5.1 Wire length
6.5.2 Protection of measuring wires
6.6 Tests
6.6.1 General
6.6.2 Continuity of measuring wire
6.6.3 No electrical contact
6.7 Quality control programme
6.8 Technical documentation
6.8.1 General
6.8.2 For assembly of measuring elements in
the field
6.8.3 For operation of a surveillance system
7 Assembly of measuring elements in field
7.1 Check upon receipt of pipe elements
7.2 Extension of an existing measuring section
7.2.1 Actual state
7.2.2 Change of system
7.3 Wiring design diagram
7.4 Assembly work in joints
7.5 Assembly check
7.6 Test after finishing a measuring section
7.6.1 General
7.6.2 Continuity of measuring elements
7.6.3 No electrical contact and moisture
7.6.4 Functional test
7.7 Test and measurement during system operation
7.8 Quality control programme
7.9 Technical documentation
Annex A (informative) - Principal function
Annex B (informative) - Principal parts of a measuring
section
Annex C (normative) - Technical documentation
Annex D (normative) - Loop test by pipe Manufacturer
D.1 General
D.2 Conductor continuity test with an optical or
acoustic signal
D.3 Measuring ohmic resistance
Annex E (normative) - High voltage test by pipe Manufacturer
Annex F (informative) - Quality control programme
F.1 General
F.2 Quality control programme for Manufacturer of pipe
elements with measuring wires
F.3 Quality control programme for Contractor assembling
the measuring elements in field
Annex G (normative) - Loop test in field
Annex H (normative) - Measuring of the electrical insulation
resistance in field
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.