BS EN 170000:1999

1 General
      1.1 Scope
      1.2 Normative references
      1.3 Units, symbols and terminology
      1.4 Preferred ratings and characteristics
      1.5 Marking
      1.6 Order of precedence
2 Quality assessment procedures
      2.1 General
      2.2 Primary stage of manufacture
      2.3 Structurally similar components
      2.4 Sub-contracting
      2.5 Manufacturer's approval
      2.6 Approval procedures
      2.7 Procedures for capability approval
      2.8 Procedures for qualification approval
      2.9 Test procedures
      2.10 Screening requirements
      2.11 Repair work
      2.12 Certified test records
      2.13 Validity of release
      2.14 Release for delivery
      2.15 Unchecked parameters
3 Test and measurement procedures
      3.1 General
      3.2 Test and measurement conditions
      3.3 Visual inspection
      3.4 Dimension and gauging procedure
      3.5 Electrical test procedures
             3.5.1 General
             3.5.2 Transmission characteristics of
                      TE01delta and TEM mode band-pass
                      type resonators
             3.5.3 Transmission characteristics of
                      TE01delta mode band-stop resonator
             3.5.4 Dielectric characteristics measurement
      3.6 Mechanical and environmental test procedures
             3.6.1 Storage
             3.6.2 High temperature ageing
             3.6.3 Robustness of terminations
             3.6.4 Soldering
             3.6.5 Rapid change of temperature
             3.6.6 Bump
             3.6.7 Vibration
             3.6.8 Shock
             3.6.9 Acceleration, steady rate
             3.6.10 Climatic test
             3.6.11 Dry heat
             3.6.12 Damp heat, cyclic
             3.6.13 Cold
             3.6.14 Damp heat, steady state
             3.6.15 Low air pressure

Applicable to waveguide type dielectric resonators of assessed quality using capability approval or qualification approval methods. Supplies the test and measurement methods which may be selected for use in detail specification for such resonators.