BS EN 60358-3:2014

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Service conditions
5 Ratings
6 Design requirements
7 Test conditions
8 Classification of tests
9 Routine tests
10 Type tests
11 Special tests - Mechanical strength test
12 Marking of the equipment
Annex AA - Typical diagram of a filter capacitor
Annex BB (informative) - High-frequency characteristics
         of filter capacitors
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Pertains to AC or DC single-phase coupling capacitor, with rated voltage higher than 1000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to a tuning device for harmonic-filters applications.

Clause 1 of IEC 60358-1:2012 is replaced by the following:

This part of IEC 60358 applies to AC or DC single-phase coupling capacitor, with rated voltage higher than 1 000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to a tuning device for harmonic-filters applications.

NOTE Diagrams of coupling capacitors to which this standard applies are given in Figures AA.1 and AA.2.